#include int forwardPin= 3 int backwardPin= 5 int leftPin= 7 int rightPin=9 int talkPin=11 byte com = 0 Once the code is uploaded, re-connect the wires (Tx-Rx / Rx-Tx) and wait until the LED on the Voice Recognition Module blink every 2/3 seconds. IMPORTANT!!! When you upload the code, disconnect Tx/Rx cables from Arduino. Eventually, you can also activate 5 servos. The following code allows you to switch 5 LEDs on/off, using the 5 specific commands you have previously recorded.
Once you finish this operation, unplug the FT232 Module and connect your Arduino, following this schematic When you are recording, be sure your microphone is attached properly to the connector (it's a bit loose). At the end, you have to type "aa21", to save the recording session. Once the module is happy about the command, will display "Command 1 finished" and you'll start the 2nd.
#Cnet coolterm serial#
Speak every time the word Start/Again appears on the serial monitor. Be prepared because as soon as you send the command, you'll start the recording session. Once you are in "Common Mode", you can type "aa11" followed by send. If nothing happens, try to press the button "Send" again, and, eventually, again. Type "aa36", press "Send" and wait the response that has to be "Common Mode". In the "Connection" options select: "Send String" and Choose "Hex", instead of "ASCII" (which is the default). Launch Coolterm app, go to connection option and to be usere to use the right COM, press the button "Re-Scan Serial Ports". Plug the FT232 module to the USB of your Computer. Wire the FT232 USB UART module to the Geeetech voice recognition board, following this schematic
#Cnet coolterm driver#
Please note that all the transmitters/receivers I've also used in other projects are 40Mhzġ FT232 USB UART Board FT232R FT232RL To RS232 TTL Serial Moduleĭownload the driver for the FT232 USB UART, according to the operating system you use. Using my voice, but keeping the functionality of the original Remote Control, so, here it is! I wanted to control my RC 360 Degree Stunt Car (which is also the motor unit I've built for my RC Lego BB8),
I've submitted this project to the Make it Move and to the Wireless contest.
0 kommentar(er)
